Echo CH611DH Instruction v.7 - Manual (Page 2)

Instruction Sheet 2
4. MOUNT CONTROLLER
Bolt the controller plate to the engine shield brace with the (2) 3/4" carriage bolts that are provided (see figure 1.
below). Secure with two nuts.
Bolt the Plus 1 controller to the controller plate with two (2) 1" bolts, two (2) 2" hex bolts and four (4) bumpers as 2.
shown below.
5. MOUNT ThE TRI-COLOR LED
The Tri-Color LED mounts on the chipper control panel, which is located on the side of the chipper. Note that the
mounting location is different for the gas and diesel models. See Section 5.1 for gas engine models or 5.2 for diesel
engine models.
BUMPER
1-1/4” BOLT
2-1/4” HEX
BOLT PLUS 1
CONTROLLER
5/16” X 3/4”
CARRIAGE
BOLT
CONTROLLER
PLATE
1/4” NYLOCK
NUT
5/16” NYLOCK NUT
ENGINE SHIELD
BRACE
IMpORTANT
Take care not to damage the existing wiring when
drilling the hole for the LED!
7.50"
1.50"
DRILL HOLE 9/16”
IN DIAMETER
Follow the measurements to drill a hole for the LED.
5.1 - DRILL LOCATION FOR GAS ENGINE MODELS