Echo CH500H Owners Manual v.2 - Manual (Page 9)

5" and 8" Skid Steer Chipper
5
Section
assemBlY
2
warnInG
if any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
remove items from the shredder area by removing
the discharge screen.
2.1 aTTaCH DIsCHarGe TuBe - CH500H
keep nuts as tight as possible while allowing the
discharge tube to freely turn.
noTe
1. attach one clamping ring(1) and one spacer ring(2) to
discharge tube base(3) using three 3/8 x 1 1/4" bolts(4)
and nylock nuts(5). tighten leaving 1/16" gap to assist
in mounting to flange. See Figure 2.1.
2. Slide the tube onto the mounting flange on the chipper
frame. the discharge clamp(1) should slide underneath
the lip of the flange. tighten the bolts and nuts to
secure it.
3. install the second half of the spacer(2) and clamp
ring(1) on the discharge tube with 3/8 x 1-1/4" bolts(4)
and nylock nuts(5).
1
2
3
4
5
6
7
9
8
10
Figure 2.3, Attach discharge deflector
Figure 2.1, Attach clamp ring and spacer
Figure 2.2, Attach discharge tube
4. lubricate the chute by applying grease to the grease
zerk at the base of the chute. rotate the chute and
apply grease until the chute rotates freely.
5. rotate the tube 360 degrees and lock it in place with
the lock pin to make sure it is mounted correctly.
6. attach the discharge deflector(6) to the discharge tube.
Connect the deflector with two 5/16 x 1 1/4" bolts(7)
through the lower hole in the discharge tube. run these
bolts through the inside of the tube, washer, deflector,
washer, and then knob(8).
7. Finish bolting the deflector to the tube with two 5/16 x
1" bolts(9) through the end hole in the discharge tube
and secure with 5/16 washers & nylock nuts(10).
1
2
4
5