Black & Decker JS670V - Manual (Page 8)

8
Switching on and off
- To switch the tool on, press the variable speed switch (1).
- For continuous operation, press the variable speed switch (1), press the lock-on button
(2) and release the variable speed switch.
- To switch the tool off, release the variable speed switch. To switch the tool off, when in
continuous operation, press the variable speed switch once more and release it.
Variable Speed Control
Variable speed is controlled through the variable speed switch (1). The tool speed
depends on how far you depress the switch. For best results, start your cut by gently
squeezing the trigger (slow speed) and gradually speed up (squeeze trigger more) as you
move through your cut.
Setting the desired cutting mode (Smart Select )(fig. D)
To select the proper orbital action for the type of material that you are cutting, follow the
steps below:
Step 1 - Turn the dial (10) as shown in figure D to the appropriate
icon. Refer to the chart on page 7 for descriptions of the 7 different
positions.
Step 2 - Insert the proper blade based on the chart mentioned
above.
Step 3 - Perform the cut.
NOTE: These settings are initial recommendations. Your
application may work best with different settings. Test these
positions on similar material prior to making finished cut and
adjust selections for desired results.
Blade storage (fig.E)
A blade storage compartment (11) is built-in
to the side of the saw.
To open the storage door:
- Grasp the tab at the top of the door and pull
outward.
The blades slide in and out of the
compartment.
CAUTION: Close door securely before
operating saw.
D
10
E
4
11