Echo CH911DH Owners Manual v.7 - Manual (Page 8)

9 INCH CHIPPER 4
SAFETY
FEED ROLLER SUPPORT MUST BE
SECuRED IN THE uP POSITION PRIOR
TO SERVICINg CHIPPER FEED AREA.
FEED ROLLER CAN FALL AND CAUSE
SEVERE BODIly HARM. CONSulT
OWNERS MANUAL FOR PROPER
METHOD OF SECuRINg FEED ROllER SuPPORT. lOWER FEED
ROllER BEFORE OPERATINg CHIPPER.
1.9 saFeTY Decals
pn 12169
2
1
KEEP HANDS AND FEET OuT OF INlET AND
DISCHARgE OPENINgS WHIlE MACHINE
IS OPERATINg TO AVOID SERIOuS PER-
SONAl INJuRy. AllOW MACHINE TO COME
TO A COMPlETE STOP BEFORE ClEARINg
OBSTRUCTIONS.
pn 12172
3
READ AND uNDERSTAND THIS
OWNER/OPERATORS MANUAL. BE
COMPlETEly FAMIlIAR WITH THE
CONTROlS AND THE PROPER uSE
OF THIS EQuIPMENT. OBTAIN AND
WEAR SAFETy glASSES AND uSE
HEARINg PROTECTION AT All TIMES
WHEN OPERATINg THIS MACHINE.
BEFORE INSPECTINg OR SERVIC-
INg ANy PART OF THIS MACHINE,
SHuT OFF POWER SOuRCE AND
MAKE SuRE All MOVINg PARTS
HAVE COME TO A COMPlETE STOP.
pn 12173
4
DO NOT OPERATE THIS EQuIP-
MENT IN THE VICINITy OF By-
STANDERS. DO NOT ALLOW
CHIlDREN TO OPERATE THIS
EQUIPMENT. ALWAYS STAND
ClEAR OF DISCHARgE AREA
WHEN OPERATINg THIS MA-
CHINE. KEEP FACE AND BODy AWAy FROM DISCHARgE
AREAS.
pn 12174
5
DO NOT OPERATE MACHINE WITHOuT
SHIElDS IN PlACE. FAIluRE TO DO
SO MAY CAUSE SERIOUS INJURY OR
DEATH.
PN 12174
pn 12175
6
KEEP HANDS AND FEET OuT OF
INlET AND DISCHARgE OPENINgS
WHIlE MACHINE IS OPERATINg TO
AVOID SERIOUS PERSONAL INJU-
Ry. AllOW MACHINE TO COME TO A
COMPlETE STOP BEFORE ClEARINg OBSTRuCTIONS.
pn 12250
7
CHECK BlADE BOlTS FOR PROPER
TORQuE AFTER EVERy 8 HOuRS OF OP-
ERATION. CHECK BlADES AND ROTATE
OR RESHARPEN DAIly OR AS REQuIRED
TO KEEP BlADES SHARP. REFER TO
OWNERS MANUAL FOR INSTRUCTIONS.
FAILURE TO DO SO MAY CAUSE POOR PER-
FORMANCE, DAMAgE OR PERSONAl INJuRy AND WIll VOID THE
MACHINE WARRANTy.
pn 14942-00
pn 12183
8
PRESS CluTCH PEDAl DOWN WITH FOOT
TO DISENgAgE BElT WHIlE STARTINg EN-
gINE. SlOWly RElEASE FOOT TO ENgAgE
CHIPPER BElT AFTER CHIPPER IS RuN-
NINg.
pn 18983-00
pn 32109-00
pn 32109-00
9
10
11
See Section 1.10 for decal locations. Familiarize yourself with all of the safety and operating decals on the machine
and the associated hazards. See the engine owner’s manual or contact the engine manufacturer for engine safety
instructions and decals. Make certain that all safety and operational decals on this machine are kept clean and in good
condition. Decals that need replacement must be applied to their original locations.
READ AND UNDERSTAND YOU
OWNERS MANUAL BEFORE
OPERATINg. IF OWNERS MANuAl
WAS NOT INCluDED OR yOu HAVE
ANy QuESTIONS, PlEASE CAll
800.247.7335 OR 701.282.5520 (u.S.A.)
DO NOT OPERATE THIS EQuIPMENT IN
THE VICINITy OF BySTANDERS. DO NOT
AllOW CHIlDREN TO OPERATE THIS
EQUIPMENT. ALWAYS STAND CLEAR OF
DISCHARgE AREA WHEN OPERATINg THIS
MACHINE. KEEP FACE AND BODy AWAy FROM
DISCHARgE AREAS. ROTATE THE DISCHARgE TuBE OVER THE
HITCH BEFORE TOWINg AND lOCK SECuREly IN PlACE.
P215/70R15 240 kPa, 35 psi
91 200