Echo CH9540H Owners Manual v.5 - Manual (Page 14)

PTO CHIPPERS 10
Section
2
1
4
5
8
11
12
12
12
13
3
discharge tube 1. : chipped materials will exit through
this tube. It is adjustable 360 degrees. The discharge
tube for the fine chip model is not adjustable. It is
designed to blow materials onto the ground.
Rotor shaft bearing cover
2. : covers rotor shaft and
front bearing.
manual holder:
3. conveniently stores your owner's and
parts manuals.
Leg stands
4. : Never move machine unless the three-
point is lifted and legs clear the ground.
Chipper chute
5. : Feed materials into the chipper
chute.
Safety bar:
6. (Not available on all models.) Push
the safety bar to stop the feed roller in event of an
emergency.
Reset/override button:
7. (Not available on all models.)
When the safety bar has been activated, the red light
will go on and the feed roller will stop. Push the reset/
override button to resume forward feed. upon start-up,
the safety bar light will be on and will need to be reset
before the feed roller will operate.
Rotor access cover
8. : Tilts up to provide access to
blades.
FEaTuRES & CoNTRoLS
Feed roller lift jack: 9. Use the jack to lift the feed roller
to inspect or service the machine. Secure feed roller
in the raised position with the snap pin.
Hydraulic fluid tank:
10. Inspect level of fluid each time
the machine is operated.
drive belt shield
11. : Remove shield to inspect drive
belt.
Three-point connection:
12. Mounts chipper to tractor
three-point hitch.
pTo driveline
13. : connects chipper to tractor PTO
shaft.
Controller light
14. : When the light is flashing green
increase RPM. The feed roller can be shifted into
Forward when the controller light is steady green. See
Section 6 for more information.
disk lock and pin
15. : use the disk lock to hold the chipper
disk in place when doing any maintenance work on it.
See Sec. 5.2.
Feed roller control bar
16. : Move the feed roller control
bar to begin feeding materials into the chipper.
Feed roller speed control
17. : Turn clockwise to increase
feed roller speed and counterclockwise to decrease.
3
understanding how your machine works will help you achieve the best results when using your machine. The following
descriptions define the features and controls of your machine.
GRavITY FEEd modEL