Echo CH9540H Owners Manual v.5 - Manual (Page 12)

PTO CHIPPERS 8
ASSEMBLY
2.5 aTTaCH dISCHaRGE TubE -
modEL CHF9540H
Bolt the discharge tube onto the mounting flange with the
eight (8) 3/8" x 7/8" bolts, nuts and washers. Put the bolts
through every other hole.
2.4 aTTaCH dISCHaRGE TubE -
modELS CH8540 aNd CH9540H
unbolt one side of the spacer and clamp from the 1.
discharge tube.
Slide the tube onto the mounting flange on the chipper 2.
frame. The discharge clamp should slide underneath
the lip of the flange. Tighten the bolts to secure it.
Bolt the second half of the spacer and clamp to the 3.
discharge tube.
Grease the discharge flange. 4.
Rotate the tube 360 degrees and lock it in place with 5.
the lock pin to make sure it is mounted correctly.
Attach the discharge deflector to the discharge tube. 6.
connect the deflector with two (2) 3/8" x 2" carriage
bolts through the bottom hole in the discharge tube.
Run these bolts through the inside of the tube, the cap,
washer, knob, and then nut. Finish bolting the deflector
to the tube with two (2) 3/8" x 1" carriage bolts through
the top hole in the discharge tube.