beautypg.com

Troubleshooting, Troubleshooting 6 – Echo CH9540H Owners Manual v.4 User Manual

Page 24

background image

PTO CHIPPERS

20

Section

TRoubLESHooTING

6

Before performing any of the corrections in this troubleshooting chart, refer to the appropriate information contained in

this manual for the correct safety precautions and operating or maintenance procedures. contact your dealer or the

factory for service problems with the machine.

pRobLEm

poSSIbLE CauSES

REmEdY

Rotor stalls or stops.

Obstructed discharge.

Use branch or similar object to clear discharge.

Plugged rotor.

clear rotor. Feed material more evenly.

Feeding material that is too

large.

Reduce size of material.

chipper does not chip.

dull chipper blades.

Rotate or sharpen blades.

drive belts loose or worn.

Inspect drive belts, adjust or replace if needed.

Attempting to feed branches

that are too large.

limit branch size to x inches in diameter.

Broken or missing chipper

blades

Replace blade.

hard to feed chipper;

requires excessive

power to chip.

dull chipper blades.

Reverse or sharpen blades.

Obstructed discharge.

Use branch or similar object to clear discharge.

Improper blade clearance.

Adjust clearance between chipper anvil and chipper blades.

Shredder requires

excessive power or

stalls.

Obstructed discharge.

Use branch or similar object to clear discharge.

Plugged rotor.

clear rotor, feed material into shredder more evenly.

Wet or green material will not

discharge.

Alternately feed dry material or install larger discharge screen.

Belt squeals when

engaging clutch.

engaging clutch too fast.

engage clutch more slowly.

Plugged rotor.

clear rotor. Feed material more evenly.

Belt tension too loose.

Replace belt or spring.

Material from chipper

wraps around rotor

shaft

Stringy, green material

bypasses chipper blades.

Rotate branch or material when feeding to cut completely.

dull chipper blades.

Sharpen blades.

Improper blade clearance.

Adjust clearance between anvil and chipper blades.

excessive vibration

while running.

drive system vibration.

check drive belts and pulleys for bad or worn areas. check for dull

chipper blades or shredder knives.

Rotor out of balance.

Inspect rotor for broken or missing chipper blades and shredder

knives; replace if needed. check rotor to see if it wobbles. check to

see if rotor is assembled correctly.

chipper blade to anvil

clearance is incorrect.

Set chipper blade/anvil clearance to recommended distance (1/16” to

1/8”).

Rotor will not turn.

drive belt too loose or broken.

Replace belt or spring.

Obstructed discharge.

Use branch or similar object to clear discharge.

Plugged rotor.

clear rotor. Feed material more evenly.

cannot engage clutch.

Improper belt installation; belt

not under belt guide.

Install belt properly; install belt under belt guide.

Improper belt tension.

Adjust belt tension. Replace belt or spring if needed.

excessive belt wear.

Not using correct belt.

contact your nearest authorized dealer to order the correct belt for

your chipper/shredder.

Pulley(s) damaged or worn.

Replace pulley(s).

Pulley(s) not in alignment.

Align pulley(s) with straight edge.

Belt(s) tension too loose.

Replace belt or spring.

Trailer sways during

towing.

Tire air pressure not correct

check tire sidewall for inflation limits.

This manual is related to the following products: