beautypg.com

Assembly, 2 attach chipper chute, Warning – Echo CH9540H Owners Manual v.4 User Manual

Page 10

background image

PTO CHIPPERS

6

Section

2.1 aTTaCH CHuTE SuppoRT

(HYdRauLIC FEEd modELS oNLY)

CHIPPER CHUTE BASE

CONNECTED TO
MAIN ASSEMBLY

3/8” x 1-1/2” BOLT

3/8” WASHER

3/8” NUT

Figure 2.2. Attaching the chipper chute (gravity feed models)

aSSEmbLY

WaRNING

do not operate this unit without the chipper chute cor-

rectly installed. Rotating cutting blades can cause se-

rious personal injury.

Figure 2.3. Attaching the chipper chute (hydraulic models)

Remove chipper from shipping crate. Place unit on a

1.

level surface before attempting to assemble. See the

Torque chart in Section 7 for the minimum tightening

torque of bolts and screws.
Attach the chute support to the front side of the chipper

2.

base with one 3/8" x 1" bolt, washer and nut. Refer to

Figure 2.1.

3/8" NUT

3/8" WASHER

3/8" X 1" BOLT

CHUTE SUPPORT

Figure 2.1. Chute support positioning

For gravity feed models, mount the chipper chute to the

frame mounting bracket using eight 3/8" x 1" bolts and

locknuts (see Figure 2.2). use three bolts on each side

and two on the bottom.
For hydraulic feed models, mount the chipper chute directly

to the feed roller as shown in Figure 2.3.
For hydraulic feed models, connect the three wires coming

from the feed chute to the connectors that are located

underneath the feed roller.

2

If any bolts or nuts are dropped in the machine, be

sure to remove them before starting the machine.

WaRNING

2.2 aTTaCH CHIppER CHuTE

CHIPPER CHUTE

CHUTE

SUPPORT

DETAIL OF CHUTE

SUPPORT MOUNTING

ON CHUTE

This manual is related to the following products: