beautypg.com

3 attach extension tray, 4 safety bar, 5 attach discharge tube – Echo CH9540H Owners Manual v.4 User Manual

Page 11: English

background image

PTO CHIPPERS

7

ENGLISH

ASSEMBLY

Figure 2.4. Attaching the extension tray

2.3 aTTaCH ExTENSIoN TRaY

(Not available on all models. Model ch8540 shown here.)

Slide the chute extension tray over the chipper chute.

1.

make sure that you position the lip on the extension

tray behind the lip on the chipper chute. Align the

bolt holes in the chute extension tray with the bolt

holes in the hinge.
Insert 3/8" x 1" carriage bolts (included in owner's kit)

2.

through the four outside holes on the extension tray

and hinge. Secure the bolts with washers and nuts.
Insert one 3/8" x 1-1/2" carriage bolt through the end

3.

of the chute support and middle hole of the extension

hinge and tray. Secure the bolts with washer and nuts.

Secure with hairpin clips.

2.4 SaFETY baR

(Not available on all models.)

Plug safety bar wire harness into the loose wire

1.

harness on the chipper frame.

2.5 aTTaCH dISCHaRGE TubE

(Models ch8540 and ch9540h)

Slide the tube onto the mounting flange on the chipper

1.

frame (Figure 2.5). The discharge clamp should slide

underneath the lip of the flange. Tighten the bolts to

secure it.
Install the second half of the spacer and clamp to the

2.

discharge tube. Rotate the tube 360 degrees and lock

it in place with the lock pin to make sure it is mounted

correctly.
Attach the discharge deflector to the discharge tube.

3.

connect the cap with 3/8" x 2" bolts through the bottom

hole in the discharge tube. Run these bolts through

the inside of the tube, the cap, washer, knob, and

then nut. Finish bolting the cap to the tube with 3/8"

x 1" bolts through the end hole in the discharge tube

(Figure 2.6).

Fig. 2.5. Attach spacer and clamp underneath tube base

Fig. 2.6. Attach discharge deflector

This manual is related to the following products: