IOGear GCS1104-KM1 Manual - Manual (Page 29)

29
FAQ
What is the difference between DVI-A, DVI-D and DVI-I? 1.
DVI-A – The “A” stands for analog, which it supports analog DVI signal
DVI-D – The “D” stands for digital, which it supports digital DVI signal
DVI-I – The “I” stands for intergraded, which it supports both analog and digital DVI signals
If you have a DVI monitor with both DVI and VGA computers and you would like to connect 2.
them through our GCS1102/GCS1104, what should you do and what do you need to know?
a. Please make sure that both monitor and monitor cable are DVI-I supported*
b. A VGA Male to Male cable for each of your VGA computer is required**
c. A VGA Female to DVI-A Male Adapter for each of your VGA computer is required***
*DVI-I Male to Male Cable (G2LDI006) is available and sold separately at www.iogar.com
**VGA Male to Male Cable (G2LVGA006) is available and sold separately at www.iogear.com.
***VGA Female to DVI-A Male Adapter (GDVIMVGAF) is available and sold separately at www.iogear.com.
If you meet all the requirements above, then you can follow the below instructions to setup your KVM.
Please make sure all devices are turned off before you start.