IOGear GCS1104-KM1 Manual - Manual (Page 19)

19
Invoke HSM, then press [F5] USB Reset
Invoke HSM, then press [b] Toggle hotkey beepers on or off
Invoke HSM, then press [s] Toggle front panel pushbutton between Mode1 and Mode2
Invoke HSM, then press [x] [Enter] Disable or enable port switching hotkey
Invoke HSM, then press [u] [p] [g] [r] [a] [d]
[e] [Enter]
Activate Firmware Upgrade Mode – Front panel KVM LED will
flash indicating Firmware Upgrade Mode is activated.
Invoke HSM, then press [r] [Enter] Restore default settings
Invoke HSM, then press [d] Capture and store monitor’s EDID on specific port
Invoke HSM, then press [m] Enable or disable mouse emulation
Invoke HSM, then press [F1] Reset keyboard and mouse under some special OS’ that do
not support USB 2.0
*Note: To exit HSM manually, press Esc or spacebar.