JLG 67SL Operator Manual - Manual (Page 31)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
3121321 – JLG Lift – 2-9
General
Begin the “Walk-Around Inspection” at Item 1, as noted on
the diagram. Continue to the right (counterclockwise
viewed from top) checking each item in sequence for the
conditions listed in the “Walk-Around Inspection Check-
list.”
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”
DURING “WALK-AROUND INSPECTION.”
NOTICE
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE.
CHECKING THIS AREA OFTEN RESULTS IN DISCOVERY OF CONDI-
TIONS WHICH COULD CAUSE EXTENSIVE MACHINE DAMAGE.
NOTE: On each item, make sure there are no loose or missing
parts, that they are securely fastened, and that no visi-
ble damage exists in addition to any other criteria men-
tioned.
1. Steer Linkage - See Note.
2. Steer Cylinder - See Note
3. Outrigger - (right front) - See Note
4. Wheel and Tire Assembly - Properly secured, no miss-
ing lug nuts. Refer to Section 6. Inspect wheels for
damage and corrosion.
5. Tie Rod and Spindle - (right front) - See Note
6. Lift Cylinder - See Note
7. Drive Hub, Right Rear - See Note
8. Fuel Tank - See Note
9. Drive Hub, Left Rear - See Note
10. Motor and Hydraulic Pump Assembly - Check engine
oil level. See Note
11. Hydraulic Reservoir - Recommended hydraulic fluid
level on level indicator on tank. Breather cap secure
and working.
12. Tie Rod and Spindle - (left front) - See Note
13. Scissor Arms and Sliding Wear Pads (Not Shown) -
See Note
Figure 2-3. Walk - Around Inspection Points (Sheet 1)