JLG E300 Operator Manual - Manual (Page 39)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121252 – JLG Lift – 3-9
5. Drive Orientation Override
When the boom is swung over the rear tires or further in
either direction, the Drive Orientation indicator will illumi-
nate when the drive function is selected. Push and
release the switch, and within 3 seconds move the
Drive/Steer control to activate drive or steer. Before driv-
ing, locate the black/white orientation arrows on both
the chassis and the platform controls. Move the drive
controls in a direction matching the directional arrows.
NOTE: To operate the Drive joystick, pull up on the locking ring
below the handle.
NOTE: The Drive joystick is spring loaded and will automatically
return to neutral (off) position when released.
6. Drive/Steer
Push forward to drive forward, pull back to drive in
reverse. Steering is accomplished via a thumb-activated
rocker switch on the end of the steer handle.
NOTE: When boom is positioned above horizontal and Posi-Track
engaged or Function speed are positioned to high, high
function speeds are automatically cut out and the
machine continues to operate at a lower speed.
7. Telescope
Provides extension and retraction of the main boom.
8. Jib
Provides for raising or lowering of the jib by positioning
up/down.
9. Jib Swing (If equipped)
Provides jib swing right or left.
10. Lower Boom Lift
Provides for raising and lowering of Upright when posi-
tioned to UP or DOWN.
11. Platform Rotate
Provides rotation of the platform when positioned to the
right or left.