JLG 601S Service Manual - Manual (Page 18)

SECTION 1 - SPECIFICATIONS
1-2 – JLG Lift – 3120866
Swing System
Swing Motor Displacement - 75 cm[3] (4.62 cu. in.)
Swing Brake - Automatic spring applied hydraulically
released disc brakes.
Swing Hub Ratio - 50:1.
Hydraulic Gear Pump (at 1800 RPM)
7.9 GPM (29.90 lpm).
Pump Displacement - 16 cm[3] (1.02 cu. in.)
Clockwise Rotation.
Auxiliary Power Pump
9.84 lpm(2.6 GPM) @ 82.7 BAR (1200 PSI)
Pump Displacement - 14 cm[3] (.244 cu. in.)
DC Motor.
Clockwise Rotation.
Hydraulic Filter - In-line
Return - Bypass Type.
10 Microns Absolute.
Charge.
10 Microns Absolute.
Hydraulic Strainers (In Tank).
30 Microns.
1.3 PERFORMANCE DATA
Travel Speed.
4WD - 6.44 Km/hr. (4 mph)
Gradeability.
(4WD) 45%.
Turning Radius (Outside)
6.2 m (20 ft. 4.6 in.)
Turning Radius (Inside)
5.25 m (14 ft. 3.9 in.).
Boom Elevation
+18.36 m (60 ft. 2 13/16 in.) -1.87 m (6 ft. 1 11/16 in.).
Machine Weight approximately
10,211 kg (22,510 lbs.).
Machine Height (Stowed)
2.56 m (8 ft. 4.75 in.).
Machine Length (Stowed)
Over Drive Axle - 8.44 m (27 ft. 8.125 in.)
Machine Width
2WS/4WD - 2.42 m (7 ft. 11.4375 in.)
Wheel base
2.48 m (8 ft. 1.50 in.)
1.4 FUNCTION SPEEDS
Machine Orientation When Doing Speed
Tests
Lift: Telescope Retracted. Lift Up, Record Time, Lift Down,
Record Time.
Swing: Boom at Full Elevation. Telescope Retracted.
Swing the Turntable off center and stop. Swing the oppo-
site direction and start the test when the turntable is cen-
tered up. This eliminates ramp up and down on the
controller affecting times.
Telescope: Boom at Full Elevation; Telescope Retracted;
Telescope Out, Record Time. Telescope In, Record Time.
Drive (Forward/Reverse): Test should be done on a
smooth level surface. Drive Select Switch should be set to
High Engine. Start approximately 7.62 m (25 ft.) from the
starting point so that the unit is at maximum speed when
starting the test. Results should be recorded for a 60.96 m
(200 ft.) course. Drive Forward, Record Time. Drive
Reverse, Record Time.
Drive (Above Horizontal): Test should be done on a
smooth level surface. Drive Select Switch should be set to
Low Engine. The boom should be raised above horizon-
tal. Results should be recorded for a 15.24 m (50 ft.)
course. Drive Forward, Record Time. Drive Reverse,
Record Time.
Platform Rotate: Platform level and completely rotated
one direction. Rotate the opposite direction, Record Time.
Rotate the other direction, Record Time.
Articulating Jib: Platform level and centered with the
boom. Start with the Jib down. Jib Up, Record Time. Jib
Down, Record Time.





