JLG 120-SXJ Service Manual - Manual (Page 13)

SECTION 1 - SPECIFICATIONS
3121810 – JLG Lift – 1-3
1.5 TORQUE REQUIREMENTS
NOTE: See Procedure Section for tightening sequence of
turntable bearing bolts.
NOTE: When maintenance becomes necessary or a fas-
tener has loosened, refer to the Torque Chart to
determine proper torque value.
1.6 LUBRICATION
Deutz F4L912 Engine
Single Viscosity Oils (CD-SE, CD-SF)
Multi-Viscosity Oils (CD-SE, CD-SF)
NOTE: Hydraulic oils must have anti-wear qualities at least
to API Service Classification GL-3, and sufficient
chemical stability for mobile hydraulic system ser-
vice. JLG Industries recommends Mobilfluid 424
hydraulic oil, which has an SAE viscosity index of
152.
NOTE: When temperatures remain consistently below -7
degrees C. (20 degrees F), JLG Industries recom-
mends the use of Mobil DTE13.
NOTE: Aside from JLG recommendations, it is not advisable
to mix oils of different brands or types, as they may
not contain the same required additives or be of
comparable viscosities. If use of hydraulic oil other
than Mobilfluid 424 is desired, contact JLG Indus-
tries for proper recommendations.
When Outside Temp is Consistently
Use SAE Viscosity
Number
-20° to +25° F (-29° to -4° C) *10W
+15° to +50° F (-10° C to +10° C) 20W-20
+40° to +85° F (+4° to +30° C) 30
Above 75° F (+24° C) 40
When Outside Temp is Consistently
Use SAE Viscosity
Number
-40° to +75° F(-40° to +24° C) *5W-20
(Synthetic)
-5° to +70° F(-21° to +21° C) 10W-30
-5° to +85° F(-21° to +30° C) 10W-40
+15° to +75° F(-10° to +24° C) 15W-30
Above +15° F(-10° C) 15W-40
Table 1-1.Torque Requirements
Description
Torque Value
Interval
Hours
Ft. Lbs. Nm
Bearing to Chassis 220 298 50/600*
Bearing to Turntable 220 298 50/600*
Wheel Lugs 180 245 100
Turntable Springs 75 102 200
Boom Chains 59 80 500
Rotator Bottom Bolt 480 672 A/R
* Check swing bearing bolts for security after first 50 hours of
operation and every 600 hours thereafter.
Table 1-2.Hydraulic Oil
Hydraulic System Operating
Temperature Range
SAE Viscosity
Grade
0° to +23° F(-18° to -5° C) 10W
0° to +210° F(-18° to +100° C) 10W-20, 10W-30
+50° to +210° F(+10° to +99° C) 20W-20