JLG 1500SJ Operator Manual - Manual (Page 59)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121261 – JLG Lift – 3-15
14. Lights (If Equipped)
Operates accessory light packages if the
machine is so equipped.
15. Jib Lift
Provides raising and lowering of the jib.
16. Soft Touch Override Switch (If
equipped)
Enables the functions that were cut out
by the Soft Touch system to operate again at creep speed,
allowing the operator to move the platform away from the
obstacle that caused the shutdown situation.
UPON ACTIVATING THE JIB STOW CONTROL SWITCH, A SLIGHT DELAY WILL BE EXPE-
RIENCED BEFORE THE JIB WILL BEGIN TO MOVE.
17. Jib Stow
Allows the jib to be returned to the stowed
position for transport and also taken out of
the transport position for machine usage.
This control operates both jib swing and the
jib lock pin in a coordinated manner.
NOTE: The Jib Telescope function only operates in the 500 lb. (227 kg for
ANSI markets and 230 kg for CE and Australia markets) capacity
mode.
18. Jib Telescope
Provides extension and retraction of the jib.