JLG 120HX Service Manual - Manual (Page 21)

SECTION 1 - SPECIFICATIONS
3120819 – JLG Lift – 1-11
1.9 SERIAL NUMBER LOCATIONS
For machine identification, a serial number plate is affixed
to the machine. The plate is located on the left side of the
frame, between the bearing area and the left rear wheel. If
the serial number plate is damaged or missing, the
machine serial number is stamped on the left side of the
frame, at the center top, below the turntable bearing; the
serial number is also stamped on the left side of the turn-
table, at center, along the left turntable upright close to the
bearing area. In addition, the last five digits of the serial
number are stamped on the top left of the fly end of each
boom section.
1.10 MAJOR COMPONENT WEIGHTS
Figure 1-3. Serial Number Locations
Table 1-7. Major Component Weights
COMPONENT LB (KG)
Platform - 36 x 72 in. (0.9 x
1.8 m) w/Control Box Sup-
port and Rotator. 243(110)
Boom (Less Extend-A-
Reach Jib and Platform) 9,502 (4310)
Jib, Extend-A-Reach and
Pivot Attach 789(358)
Turntable Complete (Less
Counterweight) 9,101 (4,128)
Counterweight 9,050 (4,105)
Lift Cylinder 809 (367)
Level Cylinder 60 (27)
Frame Complete (Includes
Tires and Wheels) 14,400 (6,532)
Wheel and Tire Assembly
(Each) 933 (423)
Complete Machine - 4WD 44,004 (19,960)