Eppendorf Galaxy CO2 Sensor - Manual (Page 4)

Galaxy O2 Sensor Setup — Instructions
4
1.2 Removing existing O
2
sensor
1. Remove the rear access cover plug to gain access to the O
2
sensor, (On older models, the
O
2
sensor can be accessed by removing the six M4 x 12 screws or the four M4 x 12 screws)
2. Unplug the connector to disconnect the sensor.
Hint!
Avoid pulling the wire leads. Hold the white connector body when disconnecting the
sensor.
1
Galaxy O
2
sen
sor
se
tu
p