Eppendorf New Brunswick -86 °C Freezers Innova U360 - Manual (Page 14)

Innova® U360 -86 °C Freezers — Operating manual
14
4. Place the shelf in the freezer, making sure all four shelf clips are supporting the weight of the
shelf.
To readjust the shelf or shelf clips, gently squeeze the shelf clip to release it from the side of the
freezer, then reposition it as needed.
4.4 Installing the voltage stabilizer
The voltage stabilizer is supplied as a removable slide-in module. The device can be installed in
the freezer at any time. Perform the following steps to install the voltage stabilizer:
1. Ensure that the freezer is turned off and unplugged before you begin to install the voltage
stabilizer.
2. Open the small front panel of the freezer (found at the bottom left of the compressor housing
on upright models), directly below the chart recorder blanking plate.
3. Remove the upper attachment bolt first, then completely loosen the lower attachment bolt and
remove the cover.
4. Remove the plug from the electrical socket at the back of the stabilizer slide.
5. Align the base of the voltage stabilizer module with the guide in the base of the freezer.
6. Slide the stabilizer toward the back of the freezer until it locks into position.
7. Close and secure the stabilizer access panel by tightening the lower attachment screw first,
then the upper attachment screw.
4.5 Lockable freezer handle
Freezers are supplied with lockable handles.
The U360 upright freezer handle is fitted with barrel locks (push in and turn key to lock, turn key
to unlock; the barrel will only lock when a key is turned to the lock position). The barrel lock may
be removed from the upright freezer handle if the lock feature is not required.
An optional padlock adaptor can provide extra security by allowing the addition of a
customer-supplied padlock to secure the freezer handle.
Removing the upright freezer handle barrel lock
Perform the following steps to remove the barrel lock from the upright freezer handle, if the lock
feature is not required:
1. Open the freezer door and place the freezer handle in closed position.
4
Installation