Eppendorf ThermoMixer FP - Manual (Page 23)

Eppendorf ThermoMixer F1.5/FP — Operating manual
23
7 Maintenance
7 Maintenance
7.1 Cleaning
Clean the housing of the ThermoMixer F1.5/ThermoMixer FP regularly.
Auxiliary equipment
•
Lint-free cloth
•
Mild, soap-based lab cleaner
•
Dist. water
Cleaning the ThermoMixer F1.5/ThermoMixer FP
1. Switch off the ThermoMixer F1.5/ThermoMixer FP and disconnect it from the power supply.
2. Clean all of the outer parts of the ThermoMixer F1.5/ThermoMixer FP with a mild soap
solution and a lint-free cloth.
3. Wipe off the soap solution with dist. water.
4. Dry all cleaned parts.
DANGER!
DANGER! Electric shock as a result of penetration of liquid.
 Switch off the device and disconnect the power plug before starting cleaning or
disinfection work.
 Do not allow any liquids to penetrate the inside of the housing.
 Use closed tubes and closed plates.
 Do not spray clean/spray disinfect the housing.
 Only plug the device back in if it is completely dry, both inside and outside.
NOTICE!
NOTICE! Damage from the use of aggressive chemicals.
 Do not use any aggressive chemicals on the device or its accessories, such as
strong and weak bases, strong acids, acetone, formaldehyde, halogenated
hydrocarbons or phenol.
 If the device has been contaminated by aggressive chemicals, immediately clean it
by means of a mild cleaning agent.
NOTICE!
NOTICE! Corrosion from aggressive cleaning agents and disinfectants.
 Do not use corrosive cleaning agents, aggressive solvents or abrasive polishes.
 Do not use lab cleaners with sodium hypochlorite.
EN
Operating manual