Eppendorf ThermoMixer FP - Manual (Page 12)

Eppendorf ThermoMixer F1.5/FP — Operating manual
12
WARNING!
WARNING! Injury from sample material being thrown out.
Sample material can be thrown out of open, improperly sealed or unstable tubes and
plates.
 Only mix in closed tubes and closed plates.
 Observe the nationally prescribed safety environment when working with
hazardous, toxic and pathogenic samples. Pay particular attention to personal
protective equipment (gloves, clothing, goggles etc.), extraction, and the safety
class of the lab.
CAUTION!
CAUTION! Poor safety due to incorrect accessories and spare parts.
The use of accessories and spare parts other than those recommended by Eppendorf
may impair the safety, functioning and precision of the device. Eppendorf cannot be
held liable or accept any liability for damage resulting from the use of incorrect or
non-recommended accessories and spare parts, or from the improper use of such
equipment.
 Only use accessories and original spare parts recommended by Eppendorf.
CAUTION!
CAUTION! Crush hazard due to moving parts.
 Do not replace any consumables during the mixing process.
 Put on the ThermoTop or Lid prior to the mixing process.
 Do not remove the ThermoTop or Lid during the mixing process.
NOTICE!
NOTICE! Caution! Strong vibration.
When mixing at high speeds, items located near the device may be moved by the
vibrations of the work surface and, e.g., fall off the work table.
 Do not place easily movable items near the device or secure them adequately.
NOTICE!
NOTICE! Damage to the display due to mechanical pressure.
 Do not apply mechanical pressure to the display.
NOTICE!
NOTICE! Damage to electronic components due to condensation.
Condensate can form in the device after it has been moved from a cool environment to
a warmer environment.
 After installing the device, wait at least for 3 h. Only then connect the device to the
mains.
NOTICE!
NOTICE! Damage from the use of aggressive chemicals.
 Do not use any aggressive chemicals on the device or its accessories, such as
strong and weak bases, strong acids, acetone, formaldehyde, halogenated
hydrocarbons or phenol.
 If the device has been contaminated by aggressive chemicals, immediately clean it
by means of a mild cleaning agent.
EN
Operating manual