B&K PT 3 series II User Manual
Page 25
Display Setup
Set the intensity of the front panel’s alphanumeric display.
',63/$< 6(783
',63/$< %5,*+7
return to setup menu
(PRESET) and
↵
(ENTER)
MENU
4
set display bright, medium, or dim
VOLUME KNOB
(BAL L) or
(BAL R)
3
enter display setup menu
↵
( ENTER)
SEL or ENTER
2
move to display setup
From setup menu:
∧
(TUNE +) or
∨
(TUNE -)
From setup menu:
or
V
1
Action
From Front Panel
From Remote
Memory Options
Your Preamplifier Tuner continually saves any settings you have made even if power is lost. However, you may
wish to save a backup of your settings in case of inadvertent changes to them.
0(025< 237,216
%$&.83 0(025<
6(/ 72 &21),50
return to normal operation
(PRESET) and
↵
(ENTER)
MENU
8
return to main menu
(PRESET) and
↵
(ENTER)
MENU
7
return to setup menu
(PRESET) and
↵
(ENTER)
MENU
6
confirm selected memory operation
note: this takes a few seconds
↵
( ENTER)
SEL or ENTER
5
activate selected memory operation
↵
( ENTER)
SEL or ENTER
4
select backup or restore memory
VOLUME KNOB
(BAL L) or
(BAL R)
3
enter memory options menu
↵
( ENTER)
SEL or ENTER
2
move to memory options
From setup menu:
∧
(TUNE +) or
∨
(TUNE -)
From setup menu:
or
V
1
Action
From Front Panel
From Remote
To restore backup settings perform the same procedure as described above but select restore instead of backup.
If you have never made a backup, then performing a restore will call back the original factory settings.
22
P/N 13010 REV 0005