B&K PT 3 series II - Manual (Page 23)

Source Names Setup
From the factory, your Preamplifier Tuner will display source names that match those printed on the rear of the
Preamplifier Tuner and on the supplied remote. However, this menu allows you to change the displayed names to
match the actual sources used. If you do not want to change the names then skip this step. Note that the tuner
name cannot be changed.
6285&( 1$0(6 9 9&5
return to setup menu —
(PRESET) and
↵
(ENTER)
MENU 8
to rename additional sources repeat 3-6 repeat 3-6 7
until all renaming complete repeat 4-5 repeat 4-5 6
move to new character position VOLUME KNOB
ˆ
(BAL L) or
‡
(BAL R) 5
change blinking character ∧
(TUNE +) or
∨
(TUNE -) ­ or V 4
select desired source for renaming
U
(SOURCE) step to source desired source 3
enter source names menu ↵
( ENTER)
SEL or ENTER 2
move to source names
From setup menu:
∧
(TUNE +) or
∨
(TUNE -)
From setup menu:
­
or
V
1
Action From Front Panel From Remote
Source Levels Setup
This setup allows you to match the levels of your sources so that there are no large changes in volume as you
change from one source to another. This is for your convenience only and need not be performed unless you wish
to. You may use a SPL meter or your ear to adjust the levels. Note that the levels will depend not only on this
setting but also on the source material being played back. You may wish to use a test disc. Note that the only
setting permitted are 0 and -6dB.
6285&( /(9(/6 9 9&5 GE
return to setup menu —
(PRESET) and
↵
(ENTER)
MENU 6
set additional source levels repeat 3-4 repeat 3-4 5
set desired level VOLUME KNOB
ˆ
(BAL L) or
‡
(BAL R) 4
select desired source for level setup U (SOURCE) step to source desired source 3
enter source levels menu ↵
( ENTER)
SEL or ENTER 2
move to source levels
From setup menu:
∧
(TUNE +) or
∨
(TUNE -)
From setup menu:
­ or V
1
Action From Front Panel From Remote
20
P/N 13010 REV 0005