Eppendorf MiniSpin plus - Manual (Page 7)

19
1 MiniSpin or MiniSpin plus
1 Rotor F-45-12-11
1 Stainless steel rotor lid
1 Rotor nut
1 Mains cable
1 Operating manual
Place the centrifuge onto a level, horizontal surface. Make sure that
the ventilation slits are not blocked! In accordance with the safety regulations of
IEC 1010-2-020 (equivalent to EN 61010-2-020), a safety distance of 30 cm should be
observed around the centrifuge during operation. No objects which could cause
additional damage in the event of a centrifuge crash should be positioned in this space.
Before plugging in the centrifuge, compare your power supply with the electrical requirements
listed on the identification plate on the underside of the device.
The mains switch is located at the rear of the device. The centrifuge is ready to operate when
the display becomes visible. Place the rotor onto the rotor axle and tighten using the rotor nut.
Before starting up the centrifuge for the first time, make sure that the rotor nut is securely
fastened.
1.2 Delivery package
1.3 Installing the device
Introduction
1 Introduction
1
02B_MiniSpin_en.fm Seite 19 Montag, 3. November 2008 10:41 10