Bosch WFMC1001UC - Manual (Page 9)

9
q Secure the connection point with
the clamp and tighten.
Standpipe Installation
q Use the elbow. Attach the elbow
to the end of the hose and insert
end of hose into standpipe.
q Use a strap or cable tie to hold
hose in place.
In-Wall Installation
q Use the elbow. Attach the elbow
to the end of the hose and insert
end of hose into wall drain.
q Use a strap or cable tie to hold
hose in place.
Drainage into a siphon
q Secure the connection point with a
hose clip(not included in
factory-supplied equipment).
Drainage into a sink
CAUTION
Ensure that the plug is not in the
drain hole.
q Attach water drain hose securely
to sink.
q Use a strap or cable tie to hold
hose in place.
q When the water is being drained,
check that the water flow out of
the sink is adequate.
Transport, such as when
moving out
Before transporting the washing
machine:
- Turn off the water.
- Disconnect the washing machine
from the power outlet.
- Dismantle the supply and drainage
hoses.
- Install the transport bolts.
i Having transported the appliance
and ensured proper installation
and connection, allow the Drain
program to run through before
starting the first wash program.
Preparing and inserting the
transport bolts
q Remove the covers.
q Prepare the transport bolts:
Loosen the screw in the sleeve
until the end of the screw is level
with the end of the sleeve.
q Insert and tighten all transport
bolts. Make sure that the tab on
the transportation bolt is inserted
in the slot on the washing machine
back panel.