Bosch WFMC1001UC - Manual (Page 16)

16
Modifiers
Delay Start
Before starting a program you can
modify by when the cycle should be
started.
The time can be delayed up to a
maximum of 12 hours (with 3 hour
increments) by pressing the Delay
Start button again.
The Start time begins running
immediately after pushing the
Start/Pause button.
Option buttons
Bleach
When this button is pressed, a bleach
cycle will be added to the selected
cycle.
The washing cycle time is extended
accordingly.
Rinse Plus
When this button is pressed, an
additional rinsing cycle will be added to
the selected cycle.
Washing cycle time is extended
accordingly.
Acoustic Signal
An acoustic signal indicates program
status (e.g. start/end of program and
operating faults.)
To activate the signal:
q Select a program.
q Press and hold the Bleach and
Rinse Plus option buttons at the
same time until a long signal is
emitted.
To deactivate the signal:
q Select a program.
q Press the two option buttons and
hold until a short signal is emitted.
i Do not activate/deactivate the
acoustic signal during a cycle.
Indicator light above the
Start/Pause" button
The indicator light conveys the
following information:
- Indicator light flashing red:
Program can be started. Adding
laundry is possible.
- Indicator light is lit red. Program is
running. Adding laundry is not
possible because the door is
locked for safety reasons.
Laundry may be added after pressing
the Start/Pause button.
Special features
Auto Load adjust
Auto Load adjust" adjusts the water
and energy consumption for each
program and determines the amount of
laundry and type of fabrics.
This process is built into your machine
and occurs automatically.
This control reduces water and energy
consumption when washing small
loads.
Unbalanced load detection system
The automatic unbalanced load
detection system spins the laundry
several times to ensure even
distribution.
If the wash load is unevenly distributed,
it will not spin (for safety reasons.)
Washing
q Turn on the water taps.
q Turn the program selector to the
desired program.
q Load the washing machine and
close the door.
The Start/Pause indicator light
flashes (red).
q If necessary, press the button(s)
for additional option(s).
The indicator light of the selected
button is lit (red).