Aries Automotive 203040-2 - Manual (Page 3)

Page 3 of 4
Driver Side Installation Pictured
(2) 8mm x 30mm Hex
Bolts
(2) 8mm Lock Washers
(2) 8mm x 22mm OD
Large Flat Washers
(outer)
(2) 8mm x 17.1mm OD
Small Flat Washers
(inner against Bracket)
(2) 8mm Hex Nuts
Hold the Bracket at an
angle. Insert the top of
the Bracket between this
lip on the body and the
body mount. Line up the
threaded Nut and Bolt
Plate with the T-Slot in
the Bracket
Once properly lined up, rotate
the Bracket into position and
line up with the holes in the
pinch weld then pull the bolt
through the top of the Bracket
Hold Bracket in place on
top of this lip on the body
Rotate into
position
(1) 10mm x 35mm Hex
Bolt
(1) 10mm Flat Washer
(1) 10mm Lock Washer
(1) 12mm x 40mm x 10mm
Nut and Bolt Plate
(1) 11mm Plastic Retainer
(1) 12mm Flat Washer
(1) 12mm Lock Washer
(1) 12mm hex Nut
Fig 3
Fig 4
Fig 5
Front