Aries Automotive 9505 - Manual (Page 2)

2-1/2” SPORT BAR
2014-15 NISSAN ROGUE
EXCLUDES 2014 “SELECT” MODEL
Page 1 of 6 6/9/14
(DP)
PARTS LIST:
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS
REQUIRED.
2. Start installation from under the front of the vehicle and remove the plastic splash guard,
(Figure 1). Pay close attention to the type and location of all factory hardware for reinstallation.
3. Locate the factory hole in the cross member under the radiator, (Figure 2). Select (1) Flat
Support Bracket, (Figure 3). Bolt the smaller end of the Support Bracket to the back of the
cross member with (1) 8mm x 35mm Hex Bolt, (2) 8mm Flat Washers, (1) 8mm Lock Washer
and (1) 8mm Hex Nut, (Figure 4). Leave hardware loose at this time.
4. Select the driver side Frame Mounting Bracket, (Figure 5). Hold the Bracket up in position
against the bottom of the frame cross member to help determine correct factory hole to use
next, (Figures 6 & 7). Line up the mounting hole in the Bracket with the hole in the cross
member. Attach the Bracket to the cross member with (1) 3/8” Self Tapping Flange Bolt,
(Figure 7). Do not fully tighten Bolt at this time.
5. Repeat Steps 3 & 4 to install the passenger side Flat Support Bracket and Frame Bracket,
(Figures 8—10).
Qty Description Qty Description
1 2.5” Nudge Bar 2 10mm Threaded Inserts
1 Driver/Left Frame Mounting Bracket 1 10mm Insert Tool
1 Passenger/Right Frame Mounting Bracket 3 10-1.5 x 35mm Hex Bolts
1 Driver/Left Support Bracket 2 10mm x 30mm OD x 2.5mm Flat Washers
1 Passenger/Right Support Bracket 2 10mm Lock Washers
2 Flat Support Brackets 2 8-1.25 x 35mm Hex Bolt
2 3/8” Special Self Tapping Bolts 4 8mm x 28mm OD x 3mm Flat Washers
2 12-1.75 x 50mm Hex Bolts 2 8mm Lock Washers
2 12mm x 30mm OD x 3mm Flat Washers 2 8mm Hex Nuts
2 12mm Lock Washers
Passenger/Right
Frame Bracket
Driver/Left
Frame Bracket
Driver/Left
Support Bracket Passenger/Right
Support Bracket
Flat Support
Bracket
Flat Support
Bracket
10mm Threaded Insert
pictured with Insert Tool