Aries Automotive 1050-2 - Manual (Page 4)

Page 4 of 5 01/20/12
Fig 4B
Fig 5A
Fig 8
Driver side frame mounting bracket (pictured
with Grille Guard in position for example only)
Fig 5
(Fig 5A & 6) Pictured without fill plate for example only
(1) 8mm x 30mm Rod Bolt
(1) 8mm x Flat washer (not
pictured)
Reinstall the fill panel and mark the cut area on the
inside of the fill panel straight up from the frame
upright. Start with a small opening and slowly enlarge
the opening to get the best fit around the brackets.
Area cut from fill panel pictured for example only.
Frame upright
(1) 12mm x 30mm hex bolt
(2) 12mm flat washers
(1) 12mm lock washer
(1) 12 hex nut
2007-11 Driver
side Shown
Upper bracket on the
outside of upright
frame
Fig 6
2012 Driver side Shown
Upper bracket placed
on the inside of
upright frame
Frame upright
Air pump
Fig 9
(1) 8mm flat washer
(1) 8mm lock washer
(1) 8mm hex nut
2007-11 Driver side
Shown
2012 Driver side Shown
(1) 10mm x 50mm Rod Bolt
(1) 10mm flat washer
Mount bracket