Snorkel T85J - Manual (Page 45)

Chapter 7 – Prestart Inspection
TB80/TB85J Fixed Axle – 0112792 41
Platform
0072531
0072530
0083985
(Platform Welder Option Only)
0083988
(Platform Welder Option Only)
0112551
0083985
0072531
0112551
0 112 55 1
• Do not operate this machine unless you are a qualified operator and have read and
thoroughly understand all information given in the Operator’s Manual and on DANGER
and CAUTION signs on this machine.
• Maintain 10 feet minimum clearance from electrical power lines and apparatus.
This machine is NOT electrically insulated.
• Do not exceed the unrestricted platform capacity shown on the platform.
• Do not operate this machine on soft or unstable ground.
• Operate this machine only on a flat level surface.
• Perform the PRESTART INSPECTION, in the Operator's Manual, prior to each work shift.
• Platform occupants MUST wear fall restraint attached to lanyard anchor points provided.
• In case of emergency, depress EMERGENCY STOP button. Pull out to reset.
• Do not use boom to lift or push this machine.
• Move controls slowly and deliberately to avoid jerky and erratic platform movement. Death or serious injury can result from not complying to the following safety rules.
Maintain 10 feet minimum clearance from electrical power lines and apparatus.
You must allow for platform sway, rock, or sag.
This aerial device does not provide protection from contact with or proximity to an
electrically charged conductor.
Death or serious injury will result from such contact or inadequate clearance.
DANGER
ELECTROCUTION HAZARD
THIS MACHINE IS NOT ELECTRICALLY INSULATED
0072530
0072530
0083988
Upper Controls