Snorkel S1930CE - Manual (Page 39)

Chapter 9 – Operation
S1930 – 0361518EE 35
Figure 9.10 – Front Rail Pins
Swing-Out Trays
Batteries and hydraulic components are enclosed in
swing-out trays (refer to Figure 9.11) on each side of the
chassis.
Figure 9.11 – Swing-Out Tray
The tray on the right side of the chassis contains the
lower controls, the hydraulic directional control valve, the
pump, free-wheeling valve, brake release hand pump, and
the hydraulic fluid filter. The tray on the left side contains
the four batteries and the battery charger.
A
Danger
The aerial platform can tip over if it becomes un-
stable. Death or serious injury can result from a tip-
over accident. Do not open the trays when the plat-
form is raised more than eight feet.
To open a tray, push down on the latch and swing the
tray open.
5. Remove the two pins that connect the front panel to
the guardrails (refer to Figure 9.8).
Figure 9.8 – Front Panel
6. Fasten the front panel to the mid rail on the right side
of the platform (refer to Figure 9.9) using the bottom
pin.
Figure 9.9 – Front Panel Fastened to Mid Rail
7. Remove the three pins on the right side of the plat-
form. Fold the guardrails down to rest on the stop on
the left front vertical rail.
8. Remove the three pins on the left side of the plat-
form. Fold the guardrails down to rest on the right
side guardrails.
9. Reverse this procedure to reposition the rails. Install
the two pins at both sides of the front of the platform,
with the pin heads to the inside of the rails (refer to
Figure 9.10). The extension deck will not fully retract
unless the pins are installed properly.
Toeboard
Top Rail
Mid Rail
Gravity
Gate
Lanyard
Anchors
Platform Foot
Switch
Pin