Snorkel TL34-sn00001+ - Manual (Page 28)

1. Fully lower all the booms.
2. Manual Outriggers – wind up the screw jacks as far as t hey will go, unlock the
spring bolts by pulling them out, then lift the outriggers until they are fully stowed.
The spring bolt can then be released and the outrigger adjusted to lock the sping
bolt in its hole.
Repeat this procedure for each outrigger.
Hydraulic Outriggers – Raise the outriggers by simultaneously depr essing the
‘Black’ motor run button near the outrigger control valve and using the appropriate
control levers, two at a time, alternating between the cage and tow bar end until
the road wheels are in contact with the ground.
3. Only when the road wheels are in contact with the ground should the unit be
lowered further until the jockey wheel makes contact with the supporting surface.
Now fully raise the outriggers until they are in the stowed position.
4. Switch off the platform and ensure all loose items/covers are secure before
towing the unit.
The machine is now ready for transportation.
21
STOWING THE MACHINE
Ensure BOTH spring bolts on each Outrigger arm are fully
located. !