Snorkel SL20-sn9300+ - Manual (Page 7)

7 SL20
Figure 5: Transporting the Work Platform
B Y F ORKLIFT
Forklift from the side by lifting under the chassis modules.
B Y T RUCK
1. Using the Control Handle, lift the platform above 2.4 m (8 ft.), then lower. The platform will
stop lowering at the Loading Clearance Height.
2. Maneuver the work platform into transport position. Press the Loading Clearance Lowering
Switch to fully lower the platform, then chock the wheels. The platform must be in the fully low-
ered position for transport.
3. Secure the work platform to the transport vehicle with chains or straps of adequate load capac-
ity attached to the front and rear lift/tie down points on both sides of the chassis.
T RANSPORTING T HE W ORK P LATFORM
Front Lift/Tie Down Ring
Forklift Here
Rear Lift Point
Rear Tie Down Ring
D A N G E R ! !
Forklifting is for transporting only.
See specifications for weight of work platform and be certain that forklift is of
adequate capacity to lift work platform.
C A U T I O N ! !
Overtightening of chains or straps through tie down lugs may result in damage
to work platform.