Snorkel AB62 - Manual (Page 9)

Operation
104044-001 AB62 Work Platform - Operator Manual Page 7
O PERATION
Before operating the work platform ensure that:
• Pre-operation and safety inspection has been completed, and any discrepancies have been corrected.
• The operator has been thoroughly trained on the operation of the machine.
• The work area is clear of all obstructions, holes, drop-offs, or persons in the route of travel.
• The surface is capable of supporting wheel loads.
Figure 5: Typical Fall Restraint Anchorage Point
W A R N I N G ! !
Always wear an approved fall restraint properly
attached to the designated platform anchorage point
when driving or elevating the machine. Attach only
one fall restraint to each anchorage point.
C
O N T R O L L E R
F
U N C T I O N S
Refer to Figure 3 on page 4 for control locations.
E
M E R G E N C Y
S
T O P
At any time during operation, press the Emergency Stop button to stop all functions in an emergency.
S
E R V I C E
H
O R N
At any time during operation, press the Service Horn button to sound an audible warning if necessary.
S T A R T I N G T H E E N G I N E
F ROM THE L OWER C ONTROLS
1. Turn platform controls key to the ON position.
• Diesel: wait for the Glow Plug light to go off.
2. Turn the chassis controls key switch to the left (CHASSIS) position.
3. Press the Start button to crank the engine. Release when the engine starts.
F ROM THE P LATFORM C ONTROLS
1. Turn the chassis controls key switch to the right (PLATFORM) position.
2. Turn platform controls key to the ON position.
• Diesel: wait for the Glow Plug light to go off.
3. Turn the platform lever switch fully clockwise to crank the engine. Release when the engine starts.