Snorkel AB46JRT - Manual (Page 43)

Chapter 7 – Prestart Inspection
AB46JRT – 0260071 39
Item Inspect For Ok
Operator’s Manual In place, all pages readable and intact
Engine
Oil level
Between full and add marks
Coolant Proper fluid level
Radiator Cap tight, good condition and clean
Fuel tank and line Tank full, cap in place and tight/no leaks
Electrical System
Battery
Condition and charged for proper operation
Battery fluid level and terminals Proper level/clean, connectors tight
Cables and wiring harness No wear or physical damage
Hydraulic System
Fluid level
Between full and add marks
Fluid filter Verify operation in the green zone
Hoses, tubes, and fittings No leaks
Cold weather warm-up Proper operation
Tires
Air filled
Good condition, proper inflation
Foam filled Good condition
Wheels All wheel lug nuts present and properly torqued
Lower Control Station
Operating controls
Proper operation
Emergency stop and emergency power Shuts off lower controls/proper operation
Level Sensor Sounds tilt alarm
Flashing Light Proper operation
All Motion Alarm Sounds when machine is operated and/or driven
Structures
Weldments –
Chassis, turntable, booms, platform, etc. Welds intact, no damage or deformation
Slide pads In place, no damage or deformation
Fasteners In place and tight
Upper Control Station
Guardrail system and lanyard anchors
Welds intact, no damage or deformation
Operating controls Proper operation
Emergency stop and emergency power Shuts off upper controls/proper operation
Horn Sounds when activated
Electrical power outlet – GFCI Proper operation
Placards and Decals In place and readable
Prestart Inspection Checklist