Micropump DB-380.B - Manual (Page 19)

19 of 20 MODEL 380 MOTOR INSTALLATION AND OPERATION MANUAL IOM # 7820
REV A
(10/99)
MICROPUMP, INC.
A Unit of IDEX Corporation
PO Box 8975, Vancouver, WA 98668-8975, USA
Phone: (360) 253-2008
Fax: (360) 253-2401
email: [email protected]
Website: www.micropump.com
MICROPUMP LIMITED
A Subsidiary of Micropump, Inc.
Howard Road, Eaton Socon
St. Neots, Cambs. PE19 3ET England
Phone: (44) (0) 1480-356900
Fax: (44) (0) 1480-356920
Website:
www.micropump.com
PUBLISHED BY
MICROPUMP INC.
A Unit of IDEX Corporation
Fifth Edition October 2000 © Micropump Inc.
All rights reserved
This manual contains proprietary information which is protected by copyright.
No part of this publication may be reproduced, transcribed, stored in a retrieval
system, translated into any language (including computer language), or
transmitted in any form without the written consent of the publisher. For further
information contact your local Micropump distributor.
Every effort has been made to ensure that the information contained in this
manual is accurate prior to printing. However, the products described in this
manual are subject to continuous development and improvement and Micropump
shall not be liable for any errors contained herein or for incidental or
consequential damages in connection with the furnishing, performance or use
of this manual.
EC DECLARATION OF INCORPORATION
(In accordance with Annex II B of the Machinery Directive 89/392/EEC)
I, the undersigned Scott Hollister, of
MICROPUMP INC.
A Unit of IDEX Corporation
1402 NE 136th Avenue
Vancouver, WA 98684-0818
U.S.A.
Declare that the pumps described in this document comply with the following EU
directives:
EN809, EN 292 Part 1, EN 292 Part 2
and within the limits specified for the machinery, is in conformity with the essential
health and safety requirements of the Machinery Directive 89/392/EEC and
subsequent amending directives.
The machinery described in this certificate must not be put into service until
the machinery in which it is incorporated has been declared in conformity
with the provisions of the Machinery Directive and its amendments.
MANUFACTURER:
IMPORTER IN COUNTRY OF USE: