Spyclops SPY-DVR Kit (ALL KITS) User Manual - Manual (Page 4)

4
1.0 INTRODUCTION
1.1 Main Menu Introduction
Right click the mouse and you will find the main menu (it can also be accessed by pressing the “MENU”
key). The main menu consists of the following components:
• X1 view Click to view which channel you want to view
• X4 view Click to view 4 channels
• Video playback Shortcut to the “video playback” option
• Manual record Set manual recording for one or all channels by choosing the “All on” option. To
turn off click the “All off” option for all or one channel
• PTZ control Shortcut to PTZ. Use this option to set the “Presets” for PTZ cameras
• Volume If you are recording audio along with video you can adjust the recording volume here
*Note: If you are recording audio as well as video, you need to go to the “Encode setup” option and choose
“AV stream” for the “Encode mode”
• Setup Goes to the “setup” menus
• Shutdown Shortcut to “shutdown” the system
2.0 SYSTEM TOOLS
2.1 User Management
• The default admin user has no password set up, to set up a password you need to highlight admin, then
select “set password”. Skip the “old password” field (since it defaulted blank) and add a “new
password”.
*Note: This will need to be done in order to view the DVR remotely
• You may add a new “user”, but remember that if you want the new user to have access to setup,
system tools AND remote you need to check the “super user” box, otherwise you can select what this
user can see/do in the checkboxes displayed under “username” and “password”. Hit “OK” and save
changes
• If you add a new “user” and forget to assign permissions, simply select the user and choose “Edit user”
to the right. You can then either pick ‘super user”, assign each permission separately or select
permissions by group of “setup”, “system tools” or “remote”
• This is also where you can delete users. Simply highlight the user you no longer want and hit “delete
user”, don’t forget to click “yes” and “ok”
*Note: if you forget your password, you can reset it by pushing the up arrow on front of the DVR 10 times
to reset the unit back to the default user