Lukas DUO Traversing System - Manual (Page 25)

25
Start-up:
DANGER / CAUTION!
According to instructions, secure the vehicle to be rerailed to prevent it rolling,
slipping and tipping!
Set up all the components to be used as described under “Setting up the DUO traversing
system”. During set-up, observe all applicable standards, directives, laws and regulations.
The separate hydraulic supply and the control of the DUO traversing system must be located
outside the danger zone!
Now connect up all hydraulic components as described under “Connecting hydraulic
devices”.
Bleeding the traverse jack:
The device must be bled before initial commissioning and after repairs:
- Connect device to hydraulic pump (see Section "Connecting the devices").
- Fully extend and retract the device several times without load.
NOTE:
We recommend that the connected hydraulic supply unit is positioned higher
than the jack during the bleeding operation.
The connections of the hydraulic jack should face upwards.
6.2 Start-up
CAUTION!
During start-up, observe all information and instructions in the separate operating
instructions for the other components of your rerailing system.
Preparations before start-up:
Before start-up, all components must be visually inspected for damage and leaks. Damaged
components must not be used and must be exchanged.
Hydraulic components must be bled before start-up takes place.