Lukas DUO Traversing System - Manual (Page 16)

16
6.1.5 Setting up the hydraulic jacks on the roller carriage
The hydraulic jacks are placed in the centre of the upper support plate on the roller carriage
if they are to be moved together with the raised load (see illustration below).
DANGER / CAUTION!
Take care when moving a load raised by a hydraulic jack (mounted on the roller
carriage) to ensure that the load cannot tilt while traversing.
It is safer to move loads when it is raised externally by hydraulic jacks, placed on
the roller carriage then traversed.
CAUTION!
When setting up the hydraulic jacks, observe all information and instructions in
the separate operating instructions for the jacks used!
NOTE:
We recommend that you use a base plate from the LUKAS range of accessories
when you wish to move a hydraulic jack that is mounted on the roller carriage.
The base plates stabilise the jack and counteract the load tipping while
traversing.