Lukas CT7 - Manual (Page 19)

19
Maintenance and service 8.
A visual inspection must be carried out after each use and at least once a year regardless
of use. In addition, a function test must be carried out every 3 years, or whenever there is
any doubt as to the safety or reliability of the equipment (observe all applicable national
and international rules and regulations relating to the maintenance intervals of the hydraulic
devices).
CAUTION!
Clean off any dirt before checking the equipment.
WARNING / DANGER / CAUTION!
In order to carry out maintenance and repair work, tools appropriate for the job
and personal protection equipment obligatory
Checks to be performed:
Visual inspection
• Control desk shows no damage or deformation
• General tightness (no leaks)
• Handles present and secure
• All screw connections tightened
• Type plate, warning labels and other markings present and legible
• Couplings must be easy to couple
• Dust protection caps must be available
• All accessories undamaged
Function test
• Control levers and buttons for proper ease of movement
• No suspicious noises
Repairs 9.
Servicing may only be carried out by the manufacturer or personnel trained by the
manufacturer and by authorised LUKAS dealers.
Only LUKAS spare parts may be used to replace all components (see spare parts list) since
special tools, assembly instructions, safety aspects, inspections might have to complied with
(see also chapter "Maintenance and service”).
During all installation work, pay particular attention to the cleanliness of all components
as contaminants could cause damage to the equipment.
WARNING / DANGER / CAUTION!
Protective clothing must be worn when repairs are being carried out, since
parts of the units can also be pressurised in an idle state.
9.1 General