Lukas SC 557 - Manual (Page 6)

6
The equipment is fi lled with a
hydraulic fl uid. These hydraulic
fl uids can be dangerous to
health if swallowed or their
vapours inhaled. Direct contact
with the skin is to be avoided
for the same reason. Please
also note that hydraulic liquids
can also have a negative effect
on biological systems. When working with or storing
the equipment, ensure that
the function and the safety
of the equipment are not
impaired by the effects of stark
external temperatures or that
the equipment is damaged in
any way. Please note that the
equipment can also heat up
over a long period of use.
Ensure adequate lighting when
you are working. Before transporting the
equipment, always ensure that
the accessories are positioned
such that they cannot cause an
accident.
Observe all safety and danger
notes on the equipment and in
the operating instructions. All safety and danger notes on
the equipment are to be kept
complete in a legible condition.
Any mode of operation which
impairs safety and/or stability
of the equipment is forbidden! Comply with all specifi ed
dates or dates specifi ed in
the operating instructions
pertaining to regular controls /
inspections on the equipment.
Safety devices may never be
deactivated! The maximum permitted
operating pressure noted on
the equipment must not be
exceeded.
Before the equipment is
switched on/started up, and
during its operation, it must
be ensured that nobody is
endangered by the operation of
the equipment. Only original LUKAS
accessories and spare parts
may be used for repairs.
Please ensure that, when
working with this equipment
or during transportation of
such, you don’t get stuck in the
looped hoses and trip.
When working close to live
components and cables,
suitable measures must be
taken to avoid current transfers
or high-voltage transfers to the
equipment. Please note that, when
cuttung or spreading, tearing
or breaking can cause falling
material, or sudden removal of
such can cause it to suddenly
catapult off: necessary
precautions need to be taken.
The build-up of static charge
with the potential consequence
of spark formation is to be
avoided when handling the
equipment. Only touch any broken-off parts
or the cut-off parts wearing
protective gloves, since the
torn / cut edges can be very
sharp.