Road Armor 2008-2011 GMC Front Bumper - Manual (Page 3)

STEP 3:
• Loosely fit brackets on frame using the factory bolts from the factory bumper.
• Install one bolt in Road Armor bumper per side using retainer clips as pictured below.
• If guarded : Wrap corners with soft material to protect fenders from scratching.
• Measure between bracket holes and position bumper bolts for easy alignment.
• Carefully guide bumper onto brackets and tighten once bumper is adjusted.
• Using a silver sharpie or paint pen mark the contour of the bumper on inner fenderwell by
pulling it tight and tracing. Once traced, double check and make any necessary adjustments
then cut excess plastic and tuck into bumper.
• Basque in glory. Congratulations! Time for a cold one!