Road Armor 2008-2011 GMC Front Bumper - Manual

Warning!
Read the instructions completely before beginning the installation. Before tightening bolts, drilling or
cutting where required, check to make sure that there are no obstructions such as brake, fuel or electri-
cal lines that may be damaged.
IMPORTANT NOTICE
IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.
BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE SURFACE PREPARATION BEFORE
HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.
ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS WITH FIT OR FINISH ARE NOT
NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.
THANK YOU
TOOLS NEEDED
-Yourself and a strong friend / bumper jack.
- Socket set, Ratchet & Wrenches (metric & standard)
( ... more than likely metric for your rig, cause everything’s imported these days,
and standard for your new bad ass Made in USA bumper.
Road Armor thanks you for supporting the American Economy! )
- Cutting Tool to Cut Through Plastic. Examples, cut off wheel, Jigsaw, Dremel,
- T20 Star Bit and Pliers
- Common Sense, a Tape Measure, and a bit of Patience
2008 - 2011 GMC
FRONT BUMPER
INSTALL INSTRUCTIONS