Road Armor 2011-2012 Ford Super Duty Front Bumper - Manual

2011- 2012 FORD SUPERDUTY
FRONT BUMPER
INSTALL INSTRUCTIONS
Warning!
Read the instructions completely before beginning the installation. Before tightening bolts check to make
sure that there are no obstructions such as brake, fuel or electrical lines that may be damaged. Also keep
in mind this is an aftermarket product and MAY require some minor shimming and or trimming, reaming
etc. To fit properly.
IMPORTANT NOTICE
IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.
BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE SURFACE PREPARATION BEFORE
HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.
ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS WITH FIT OR FINISH ARE NOT
NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.
THANK YOU
SUGGESTED LIGHTS THAT FIT THIS UNIT:
PIAA 510 - www.piaa.com - Part Numbers (5161, 5164, 5192, 5190, 5196).
Warn 350F - www.warn.com Part Number (82410).
TOOLS NEEDED
-Yourself and a strong friend / bumper jack.
- Socket set, Ratchet & Wrenches (metric & standard)
- Common Sense a Tape Measure and a bit of Patience