Step 4 – Road Armor 1994-2002 Dodge 2500,3500 Front Bumper User Manual
Page 3

Install the first Road Armor frame bracket using
stock hardware. Refer to picture to determine
how the bracket mounts onto the frame. Hand
tighten all bolts to allow for adjustment once
bumper is on truck.
Picture 6
Repeat this step for the other side of the truck
• Once both Road Armor frame brackets are in-
stalled on truck it should look like the picture
below.
Picture 7
STEP 4:
• Insert one bolt plate into the inner slots on the
bumper weld in brackets. Once bolt plate is
inserted into the inner slots push one ½” push on
retainer to hold bolt plate onto bumper.
Picture 8
Repeat this step for the other side of the bumper
assembly.
• It’s time to install your road armor bumper. Using
either a lift or a couple buddies, move the bum-
per into place. The bolt plates that are already
placed into the bumper will line up with the slots
in the frame bracket. If needed use a tape mea-
sure to align the bolt plates with proper spacing
to make mounting the bumper easier
• Lift the bumper and slide the bolt plates into the slots
in the frame brackets. Once bolt plates slide into to
frame bracket slots fasten with one ½” flat washer, ½”
lock washer, and one ½” nut on each bolt in each bolt
plate. Hand tighten all hardware.
Picture 9
Repeat this step for the other side of the bumper.
• Make final adjustment to bumper and tighten all
hardware. Once bumper is fully adjusted attach stain-
less steel road armor logo to bumper with supplied
hardware.
5
6
8
7