beautypg.com

Apple Xserve (Early 2008) DIY Procedure for Rear ID Tab User Manual

Page 23

background image

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions

23

Note: When installing the processor on the logic board, align the processor notch with the
tab on the processor holder, as shown. Then lower the processor straight down onto the
socket.

Rotate the top of the holder to the closed position.

8.

Engage the latch on the metal processor holder. Repeat the steps above for the second

9.

processor.

Holding the heat sink by the slotted sides in one hand, reconnect the 2-pin thermal sensor

10.

cable for the heat sink to the logic board.
Note: Make sure the connector on the sensor cable is oriented as shown, with the gold
fingers facing up.

See also other documents in the category Apple Software: