Apple Xserve (Early 2008) DIY Procedure for Processor - Manual (Page 8)

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 8
Processor
Release the latch on the metal processor holder. 1.
Rotate the top of the holder to the open position. 2.
Carefully lift the processor out of the holder. 3.
Important: When removing or installing a processor, always hold the processor by three
corners. Be extremely careful not to touch the gold pins on the bottom of the processor, as
this type of connector is very sensitive to contamination. Also be careful not to touch the
gold pins in the processor socket on the logic board.