Apple Power Mac G4 (Digital Audio) - Manual (Page 60)

60 Chapter 4
5 Install the ATA drive in the U-shaped bracket.
Note: The tinted screws illustrated below indicate the four low-profile screws that came
in the computer’s accessory kit. The untinted screws show the screws that came with the
new drive.
If you’re installing a drive in the lower part of the U-shaped bracket, use the low-profile
screws to attach the bottom of the drive to the carrier.
Attach an additional ATA drive (1" high)
to the upper portion of the drive carrier
by screwing it into position on its sides.
Attach the two screws on this side first.
These two
tabs will
bend
inward as
you tighten
these two
screws.
ATA drives that are 1" high are attached
to the lower portion of the drive carrier
from the bottom.
Position the hard disk drive on the drive carrier so that the ribbon cable connector and the
power cord connector are accessible.