Apple Xserve (Early 2008) DIY Procedure for Video Mezzanine Card - Manual (Page 4)

Xserve (Late 2006/Early 2008) Video Mezzanine Card Replacement Instructions 4
Remove the four 8.5-mm long Phillips screws that secure the mezzanine card to the logic 2.
board.
Pull up evenly on all sides of the card to disconnect it from its logic board connector under
3.
the card, and remove the card from the Xserve.
Installing the Replacement Video Mezzanine Card
Align the replacement video mezzanine card with its logic board connector and press down 1.
gently and evenly on the card to seat it.
Replace the card’s four mounting screws 2. , and secure them in the order shown above.
Replacing the Right PCI Riser Card
Align the right riser card with its slot on the logic board and press to seat the riser. 1.
Tighten the captive screws that secure the riser bracket to the back panel. 2.
Closing the Xserve
Replace and secure the cover. 1.
Slide the Xserve back into the rack, and tighten the front thumbscrews to secure the Xserve 2.
in the rack.
If the server case was locked, use the enclosure key to lock the security lock on the front 3.
panel.