beautypg.com

Removing the installed video mezzanine card – Apple Xserve (Early 2008) DIY Procedure for Video Mezzanine Card User Manual

Page 3

background image

Xserve (Late 2006/Early 2008) Video Mezzanine Card Replacement Instructions

3

Removing the Installed Video Mezzanine Card

Note: Before you can remove the video mezzanine card, you must first remove the right PCI riser
card and any installed expansion card.

Right PCI Riser Card

Loosen the two captive screws that secure the right riser bracket to the back panel.

1.

Carefully pull up on the right bracket and riser to disconnect the riser from the logic board. If

2.

an expansion card is installed in the riser, leave it attached.

Tilt the expansion card up so that its port clears the enclosure, and remove the riser and card

3.

from the Xserve.

Video Mezzanine Card

Locate the video mezzanine card.

1.